How to use this calculator
- Choose US customary or metric measurements.
- Enter the length, width, and layer depth for each sand area, such as a paver bedding layer or a play area.
- Add every differently sized area separately.
- Set a waste allowance for spillage and uneven grade, then calculate.
How the calculation works
Sand is ordered by volume. Each area is treated as a flat rectangular layer, so its volume is length × width × depth. The calculator adds the layers together and then applies the waste allowance you choose. A thin, even layer such as paver bedding is very sensitive to depth, so measure it carefully.
Formula
Layer volume = length × width × depth Planning volume = combined layer volume × (1 + waste % ÷ 100) Cubic yards = cubic feet ÷ 27 (sand layer)
Worked example
A 12 ft × 10 ft patio with a 1 in bedding layer needs 10 cubic feet of sand (12 × 10 × 1/12). With 10% waste, the planning volume is 11 cubic feet, or about 0.41 cubic yards.
Coverage by layer depth
Sand layers are thin, so the area per cubic yard is large.
| Layer depth | Sq ft covered by 1 cubic yard |
|---|---|
| 1 in | 324 |
| 1.5 in | 216 |
| 2 in | 162 |
A second example: a sandbox
A 4 ft by 4 ft sandbox filled 8 in deep needs 10.67 cubic feet. With 10% waste that is 11.73 cubic feet, or 0.43 cubic yards.
Pick the right sand
The calculator reports volume. Bedding sand, play sand, and joint sand are different products, and suppliers specify which is right for a use. Ask about the product and whether it is sold by weight or volume.
Common mistakes
- Combining the bedding layer and the joint sand into one number.
- Forgetting that a flat surface needs a level bedding layer, so the depth you enter should be the finished layer.
- Measuring inches as feet.
Uses that need different amounts
Sand has several jobs in a home project, and the volumes are very different. A leveling layer under pavers covers a large area but is thin. Joint sand between pavers is a small fraction of that. A play area is deep but covers a small area. Treat each use as its own calculation and add them up at the end.
The product also differs by use, so confirm with the supplier or the paver manufacturer which sand to order. The calculator turns area and depth into volume and does not choose the product.
More common mistakes
- Using a thick bedding depth because it is easier to level, which increases the amount you buy.
- Mixing up the area to be covered with the area of the surface above it.
- Ordering one product for jobs that need different sands.
Project considerations
- Bedding layers are usually thin, so a small error in depth changes the volume noticeably. Confirm the depth recommended by the paver manufacturer or your installer.
- Loose, compacted, damp, and dry sand do not occupy the same volume, and no density or weight is assumed here.
- Sand for filling the joints between pavers is a separate, much smaller quantity than the bedding layer. Calculate each use on its own.
Frequently asked questions
Why is the result in cubic yards and not tons?
Suppliers sell sand by volume or by weight, and the weight of a cubic yard depends on the type of sand and its moisture. This tool reports volume and leaves the conversion to your supplier.
How much waste should I add?
Ten percent is a common planning allowance for spillage and uneven ground, but a flat, well-prepared surface may need less. Adjust it to your site.